Alltronix International Inc

• iOLM (Intelligent Optical Link Mapper) – automatic configuration and multiple measurements on the same link provides the best possible measurements regardless of fibre configuration
• Onboard PDF reporting
• Macro bend detection
• Short attenuation dead zone: MM: 2.5 m/SM: 3 m and event dead zone: MM: 0.5 m/SM: 0.7 m for accurate location and characterisation of events
• Quad wavelength (850/1300/1310/1550) for both multimode and single-mode testing
• Each fibre may be tested at two wavelengths in a single Autotest
• Provides results in only a few seconds
• Interchangeable fibre adapters with a wide variety of available configurations
• Transfer test results to PC via USB flash drives or USB cable
• Optional video inspection micro scope to check connectors for cleanliness or damage
• Provides simple PASS/FAIL results and macro bend detection in single-mode fibres that helps users identify bends or kinks in the cable, saving time during installation and troubleshooting
• Small size for one handed operation
• Rubber over-mould for enhanced drop protection
• 1 lithium-ion battery provides up to 12 hours operation
• Warranty is 1 year and we recommend an annual calibration
• Rugged carrying case for field use

A hand-held, battery-powered tool, the VFF5 projects a highly visible red light into a fibre optic cable. The VFF5 is used to check continuity of cabling between termination points and to locate bends or breaks in fibres at splicing and termination points.

The VFF5 is useful over a distance of approximately 5km (3.1mi) into multi-mode fibre and single mode fibre. Use it as a stand-alone first-line basic troubleshooting tool, or in conjunction with an OTDR to pinpoint faults. Any breaks will be seen as a conspicuously glowing or blinking red light area (in 3mm or smaller cables).

The VFF5 is equipped with a high-power, day light visible 650nm laser diode which operates either in continuous or flashing mode. The design prevents battery drain due to accidental activation of the tool while inside a tool pouch.

Two AA batteries provide over 30 hours of operation in continuous mode and 80 hours of operation in flashing mode.

The unit is packaged in a pocket-sized, rugged metal housing and is fitted with 2.5 mm universal connector that accepts ST, SC and FC optical connectors.

Testing of fibre continuity and locating bends or breaks in small fibre optic cabling